AWD button not working?
#1
AWD button not working?
1995 425 Magnum 4x4: I just got this running and had it out yesterday engine seems strong but when I hit the AWD button nothing happened. I did some rewiring on the lights because they were all screwed up, so i'm thinking that maybe the AWD wiring is messed up too. I got this thing for $400 bucks, I can't complain too much. I've never owned a polaris before, should I hear anything engaging when I hit the AWD button? because i'm not hearing anything. I have four wires running out of the switch 1 yellow, 1 brown, 1 gray, 1 gray w/ white stripe. All 4 run into the box on the left side of the gas tank. Does this seem right?
Rob
Rob
#3
AWD button not working?
"I have four wires running out of the switch 1 yellow, 1 brown, 1 gray, 1 gray w/ white stripe"
According to my wiring diagram in the Haynes manual your four wires are as follows...
Yellow - Headlight
Brown - Ground wire for AWD indicator light
Grey - (English spelling [img]i/expressions/face-icon-small-wink.gif[/img] ) Switch to front wheel drive coils and AWD indicator light.
Grey/white - AWD Switch to the over-ride switch and Trans switch.
Check the voltage at the front wheel drive coils (with the switch ON), between the end of the grey wire and a ground point - if there's no voltage you have a bust switch, if there's a voltage your coils are bust. Not sure how easy the latter would be to replace.
Good luck...
#5
Thread
Thread Starter
Forum
Replies
Last Post
KimSJoh
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
14
07-18-2015 07:20 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)