Tether Install, HELP PLEASE, ASAP
#1
Tether Install, HELP PLEASE, ASAP
I have a 2005 Trailblazer 250 that I need to install a Tether Switch on ASAP. The only tether I could get quick is a really nice handlebar mount that is open when the tether is attached and closed when the tether pops off. I need to know what wires I can short together to stop the engine, without ruining any electric modules. Does the Run Switch on the Handle Bar work this way? If so I could probably use those wires. I will do some investigating tonight with an Ohm Meter, but I really need some advice.
I have ordered a manual with wiring schematics included, but it will not be here on time.
Thanks All
I have ordered a manual with wiring schematics included, but it will not be here on time.
Thanks All
#2
#3
Tether Install, HELP PLEASE, ASAP
Thanks for the reply, if you are right I could still make that work, I could just run one side of the tether to ground and the other side to the appropriate wire that gets grounded at the switch. I hope you are right...I just need to find a way to make it kill the motor by making a connection, not breaking one, even if it is just connecting to ground.
Thanks...Anyone else been through this???? I am still flying pretty blind.
Thanks...Anyone else been through this???? I am still flying pretty blind.
#4
#6
Thread
Thread Starter
Forum
Replies
Last Post
jrooker6
Polaris
18
04-23-2016 07:36 PM
slowgsxr97
Classifieds, Garage Sale & Swap Shop
1
09-08-2015 07:33 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)