Rims for Predator
#4
Yes, I like the coolers. I don't think you need them...unless you ride in hot conditions, or have engine mods. They do help though(mine are big however.....lots of fins).
Sand tires, depend on your riding style. You could post this question down in the dunes section(or the tires section)....or even just search it.
My opinion.....if you like dragging, and hooking up in a straight line....then get strait paddles......if you like trails(or some of both)......get v paddles.
For v paddles, I like the new itps one's.......and for straight paddles......haulers possibly(not sure).....look up skat-trak
Sand tires, depend on your riding style. You could post this question down in the dunes section(or the tires section)....or even just search it.
My opinion.....if you like dragging, and hooking up in a straight line....then get strait paddles......if you like trails(or some of both)......get v paddles.
For v paddles, I like the new itps one's.......and for straight paddles......haulers possibly(not sure).....look up skat-trak
#5
I was looking at the Kenda Gecko plus tires. They are a vee tread.
Brad,
I have noticed that the fan on Preds come on alot. That is way I asked about the fins.
Thank you for the info on the rims.
Should I get front sand tires? Will the Razor fronts do find?
Brad,
I have noticed that the fan on Preds come on alot. That is way I asked about the fins.
Thank you for the info on the rims.
Should I get front sand tires? Will the Razor fronts do find?
#6
Yeah, I think the gecko's are good too. As for fronts.....if you are planning on going a lot.......you probably need them. If not.....they don't make that much of a difference
The pred's fan is set to come on pretty low......it doesn't take much to get the fan on......you'll get used to it
The pred's fan is set to come on pretty low......it doesn't take much to get the fan on......you'll get used to it
Thread
Thread Starter
Forum
Replies
Last Post
Elkaholic
Land, Trail and Environmental Issues
1
Sep 6, 2015 02:44 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)




