Hey guys i was wondering about a k&n filter for my atv. I was wondering if i could just get it at Auto Zone or something like that? Also how much do they cost?do i have to remove anything or just replace the same filter?

 

i dont think u have to remove anything if anything u might have to remove the top cover on the air box...as for the auto zone i dont know if u could or not

 

I don't think you're going to find that exact size filter at Autozone, but I suppose you could take your existing filter down there and see. Otherwise, Dennis Kirk or Rocky Mountain I'm sure will have one that'll work. Be sure to get the Outerwear with it.

To replace the filter, take the seat off with the side latch. Remove the two wingnuts and washers on the aluminum cover to remove the airlid. Remove another wingnut and washer to remove the filter. When replacing, be sure it's seated correctly before putting on the smaller cover and wingnut again. You don't want to crush it.

That's all there is to it.

 

Hey thanks a lot you guys are really informative...i have another question would yall recommend a clutch kit for it would that give me more take of power and acceleration? Could i install it instead of a dealer.

 

You have just one man you need to talk to for modifying these machines. Call Rick Ritter at 618-644-3211, and visit his website at http://rittercycle.com/polaris.htm ... He is the god when it comes to the Polaris 400 engine.

Check out what my 2000 Scrammy 400 4x4 does with just the pipe, spark arrestor, jetting, and primary clutch spring...

Polaris RcR Hot Lap Video

Good luck!