I noticed today that the A-Arm on my '01 Scrambler 500 4x4 was a little loose (it has some play to it). The bushings look good. Is there an easy way to fix this? I tried to tighten up the nuts on the outside, but I don't think I have the right socket and wrench?!?!?!

 

if its loose, then your bushings are worn. they may look like they are good, but they need replaced. EPI sells a good replacement set, reasonably priced too.

X

 

Hmmmm... that isn't bad. Are they hard to install? I have every wrench in the world, but can't find one that fits on those nuts?!?!?!?

 

once you find the right wrench, its not too bad of a job..... LOL

X

 

<div class="FTQUOTE"><begin quote>Originally posted by: cdrmotorsports

I noticed today that the A-Arm on my '01 Scrambler 500 4x4 was a little loose (it has some play to it). The bushings look good. Is there an easy way to fix this? I tried to tighten up the nuts on the outside, but I don't think I have the right socket and wrench?!?!?!</end quote></div>

That dont mean bushings are bad they could have rattled loose mine have and bushing is fine just need some loc tite on em. Do u have grease fittings on em? make sure they are full if u have grease gun just couple pumps no more then 2 or 3. if u live somewhere hot then factory loc tite on bolts could have melted off. but if u feel the need then do bushings but not needed in my opinion