Has anybody else ever installed EPI ball joints? Before I put mine in I noticed that there was not a hole for the grease to go through like the orginal polaris ones had, so I drilled one in it. Well anyways after I put one in and tried to grease it, it would not take grease and just will press the ball joint out of the socket. It even bent the metal plate that holds it in. Whats with them not takeing grease or even designed to? Any one else have this problem? Thanks.

 

If like our oem updated replacement balljoints they are pregreased and not designed to be greased. STUPID,I know! Good luck

 

dang and I already drilled it. So what do you do with the grease zerk so that someone wouldn't "accidently" grease it and cause problems?

 

CAN remove zerk and a little Jb weld can do wonders!

 

sounds like a plan thanks

 

On non-greasable ball joints you can add grease with a needle through the rubber boot.

 

On non-greasable ball joints you can add grease with a needle through the rubber boot.