well i did it today. shatterd the front rim. the day before the wheel bots striped
#32
#33
well i worked on making my 3 1/2" x 3 1/2" x 1/4" thick alum plate round piece. now tomorrow im gona take a bit off the back side so it still has a lip to make a snug or tight fit so i can glue it into place. im also gona cut the old wheel studs in half and drill out a half inch of the stud holes in the rim so the lug nut fit lower so that the clock arms can go over the top of them. here is an updated pic with the lug nuts and center cap (not finished yet tho).
#36
well i cut the old wheel studs in half so i could cut the lug nuts shorter. this way the lug nuts sit lower in the rim holes. so hopefully when i get the clock parts the clock arms will go righ over the lugnuts now. the center cap has been cut to fit snug into the center of the rim to mount the clock parts to it. and i also made a hangar on the back.
pictures of it almost compleat. gona work on the numbers, and wait for the clock parts.
pictures of it almost compleat. gona work on the numbers, and wait for the clock parts.
#40
thanks for all the comments guys!!!!