Can't shift gears if bike's running 06 sp500
#1
Can't shift gears if bike's running 06 sp500
I can not shift gears if the bike is running, if engine is off it shifts fine. I removed the linkage, trans switch and sector cover I remove all gears and lubed them and reinstalled everything. The bellcrank was replaced because it was bent and the gear was tore up a bit. And it didn't fix anying. I have looked at a lot of posts on here and read the manual and I'm stuck.
Also there is no adjustment for the linkage or bellcrank ????
Also there is no adjustment for the linkage or bellcrank ????
#3
#6
#7
The bike is a efi so there is no idle as far as I know, I did a resistance test on the idle air control, it tested out fine, even swaped it out off of a different throttle body. In N it idle is about 1200rpm in gear is about 1150 rpm. The bike changes gears just fine if the engine is not running.
Trending Topics
#9
My 07 sp500 EFI idles at 1150-1200 and shifts very smoothly and clutch engages about 1350. Does your quad have EBS? Maybe the one way bearing on the primary is dragging or seized?
#10