I have a 90 trail boss 4wd. All the electronics on the quad seems to be working fine, however when I flip the 4wd switch the indicator light comes on for about 2 seconds then I hear the inline 10amp circuit beaker tripping. If i leave the switch alone I can hear the beaker reset and it trips off again at the same time the 4wd is not engaging. I did notice the reverse over-ride switch looks like its pressed in (stuck in) . I`m leaning towards a dead short somewhere and I will find it but thought someone here, may have had the same problem and could save me some time as to where to look.
Thanks.

 

Anyone ever have this problem? what did you do to fix it?

 

I sent you a PM. check it. still working on this for ya. bear with me.

 

Got your PM thanks, message sent back.

 

THREAD UPDATE: Short has been narrowed down to the right front wheel. When I unplug the power supply wire to the engagement coil the other wheel stays locked and the circuit beaker dont trip. I`ll figure out what the problem is tomorrow and post it here. Thanks for all the help Jaster94.

 

Turns out that the magnetic coil in the right front wheel is toast, I was hoping it was a broken wire. looks like i`m off to get raped at the steelership.

 

Maby post in the classifieds"part needed".