how to check warning lights???
#1
#2
Check under pod for connections to the three sealed bulbs, 4040052,4040053,and 4040054 bulb #'s. Does Hi beam light work? could be just burnt out bulbs. Common brown ground wires to all three,with blue hot wire to high beam,red to hot I think and a purple wire? can use a simple test light or ohm meter on hi beam hot wire with switch on,should have voltage,if light not on replace the bulb,just pops out of pod. You can apply voltage to the others and just touch a brown wire for ground,should show good or bad. OPT
Thread
Thread Starter
Forum
Replies
Last Post
bzdok1234
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
30
02-23-2016 01:55 PM
KimSJoh
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
14
07-18-2015 07:20 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)