335 idle problem
#1
so was riding everything fine. we were riding the new lost trails in pa. If you know it is rocky to put litely. it started to run high as we were riding after we stopped first wouldnt go into gear at all. took shifter off dropped back in was fine. The idle was hi so high couldnt but into gear without grinding. Had to start in gear. will go about 15 mph w/o throttle. next day started right up still running hi about 4 hours later wont start at all. carb was cleaned out air filters changed. any ideas?
#2
Check for any throttle cable binding and that you have at least 1/8" slack at the thumb throttle. If this checks out it could be a diaphragm spring, slide needle or carb slide problem.Also could be as simple as trying to lower the idle screw under the carb. OPT
#4
so i was ridding my son and he was holding the inside handle bar and had his hand on the adjuster screw on the cable...duhhhhhh but i dint even know it was there... was not fun comming down the mountain. thanks for the help....
#6
Thread
Thread Starter
Forum
Replies
Last Post
KimSJoh
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
14
Jul 18, 2015 07:20 PM
ranvette
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
7
Jul 12, 2015 06:34 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)





