Water in engine?
#1
#2
#3
#4
Bush,
two other possibilities, one is that you might have gotten water down around your sparkplug... that will cause it to either die or just start "banging out" really bad..
Another is that you got water inside the "pullcord" housing where your stator assembly and magnetic pulser are located, I would check the bottom drain for water on that and if you find water, take the cover off and seal it with a thin coat of RTV silicone and a new gasket.. After you get it back on, put some grease on the inside of the pullcord handle boot (where it contacts the housing) and seat it on there good, then put a hoseclamp on that bad boy and you're ready to go play submarine.
Good Luck...
two other possibilities, one is that you might have gotten water down around your sparkplug... that will cause it to either die or just start "banging out" really bad..
Another is that you got water inside the "pullcord" housing where your stator assembly and magnetic pulser are located, I would check the bottom drain for water on that and if you find water, take the cover off and seal it with a thin coat of RTV silicone and a new gasket.. After you get it back on, put some grease on the inside of the pullcord handle boot (where it contacts the housing) and seat it on there good, then put a hoseclamp on that bad boy and you're ready to go play submarine.
Good Luck...
Thread
Thread Starter
Forum
Replies
Last Post
KimSJoh
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
14
07-18-2015 07:20 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)