I've been driving through the water again and I found I have some rust preventing the driven clutch from being pulled off the transmission shaft. Does anyone know what the threads are on this clutch? I will try to make a tool similar to my primary clutch pulling tool.

 

There are pullers available that are the similar to the primary unit. Hot Seat,or your local dealer will have them. You could also stop by your local dealer, and I'm sure they wouldn't mind pulling it off for you. A little tip, you can smear a very thin film of anti-sieze in the shafts before installing either clutch. A VERY THIN FILM, you don't want that flying around and getting on your belt. Don't forget a little blue loctite on the threads of the bots either. Sorry if you already knew this.

Ken