so how would i go draining the oil in the tranny? my oil on the front of the quad is fine no water there. would it just be drained outa the hole the tranny goes into? any help would be great!




thanks
BigBadBrad

 

On the same side as the dipstick, go straight down to the bottom of the tranny. The drain plug actually sticks out the same side but its at the very bottom.

 

Doing some searches to get some guidance. The thing just won't start. Won't even pop. I put in a new spark plug and ensure it was getting spark. I cleaned out the carb and ensured all jets were not plugged. I make sure in-line fuel filter was ok and gas getting to the carb. I put my hand over the carb and it feels like it's getting good compression. I can see the piston going up and down. It just died one day. The only thing I can think of now is bad gas. Going to try starter fluid to see if I can get it to at least pop.

Suggestions?