I have a 1988 lt250r and I am trying to get the front hub off to change the bearing. The left side came off fine and I got them changed in no time but the other side wont come off. Its like the spacer or one of the bearings is rusted on. I heated up the hub and beat on it and it still wont come off. Any suggestions??

 

Not really a good suggestion, but after exhausting all other options available I took a piece of wood 2"x2"x a foot or so and cut a angle on the end so it was 1/2 to 1" wide. Then placed it against the inside of the rotor as close to the middle as I could get it to minimize the chance of bending them and pounded till the hubs came off. Make sure to apply lots of grease so they dont stick next time.

 

I dont know what else would work besides what tom said and heating them up, mine slipped right off when we heated them up on the banshee.