the same fmf pipe that came out of the quad, will not go back in!! it doesn't line up with the cylinder manifold. anyone know what's up with this. it's a 92 lt250r??

 

You are using too small of a hammer.

 

if only that was the case! i wasn't good as a kid, putting the round peg in the square hole!

 

i had to fidget with mine for a while.the hardest thing is to fit the keihin carb in the boots.that takes me like 2 hours....

 

the pwk38 is a lost cause i need new boots for it. i tried cutting, heat gun..no go. my pipe just doesn't line up. i'm lost for words??!?!? i took it out, so i know it used to fit. i even tried rotating the manifold (useless) out of desperation.

 

it came off.it has to go back on.just keep rockin it and stuff.my carb isnt too big for the boots its just the boot that comes out of the engine curves down and to the right when i think it should come straight out.the boots just dont line up straight with eachother what so ever.