Boring Out Cylinder
#11
Boring Out Cylinder
Will I have to bore it everytime I do a top end or can I just hone it a few times after this? So when looking for a .020 or whatever piston for a 68mm or 68.5 or whatever which size would I wan't. I don't know if he said it was at 68 now and he was going to the next size I think he did or that he was going 68mm I don't think this was it. I'm new to all this as I'm sure you guys can tell.
Thread
Thread Starter
Forum
Replies
Last Post
Quadzilla Heritage
Classifieds, Garage Sale & Swap Shop
0
09-25-2015 01:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)