lt250r engin ?????
#6
lt250r engin ?????
it is centrifugal force it move up and down freely the power valve has the spring tension . in the manual it will tell you how to set it . . Dont quote me but mine i think was put it in the cap on the spring then turn it to the lines that are mark 250. As the mortor revs it turns to raise port timing.
#7
lt250r engin ?????
take out the 2 screws holding the the powervalve cap on left side of your jug,take out spring clean it and put back in making sure its in the slot of the power valve. isert screws do not tighten them yet. turn cap 360 degrees counter clockwise. tighten screws . your done. if you use search feature on forum u wont have to wait for an answer on alot of this stuff as its been asked before. good luck