When I changed my oil and refilled it the oil didn't make it to the check window on the front of the motor. I added oil until it wouldn't take any more. Still I can't see any oil through the window. Is this normal? I ran the motor a little bit and oil comes out the breather on top of the motor. I can only see a little oil through the window. Am I doing something wrong?

 

I'd find out how much oil it is supposed to take and add that much. The glass on my blaster became cloudy so I can't tell how much oil is in it. on my 250r therre is a screw you take out an oil flows out when it is full. To much oil in the transmission is bad, you blow the seals out of the transmission.

 

Does anyone know how much oil a LT500r should take?

 

I found out I put way to much oil in. I needed about 1.06 quarts and I put in 4. There is a screw just below the rear brake lever that lets you know you have thright amount of oil when removed. Thanks for your help.

 

Nice quadzilla

 

i did the same thing on my 87 lt250r that glass is your power valve glass not your oil glass. should say how much right above your fill hole. i never seen the oil in the glass eiether go figure lol.

 

1000ml. Says it on motor by oil cap