lt500r wondering how they are supposed to run
#11
Have you figured out the exhaust valve V8?
1st check: How's the spring look? If it's bent or looks bad, replace it!
2nd: Valve free and turns easy?
put the cap on the spring with no preload (note where the pointer is oriented) turn the spring/cap assembly 180 degrees COUNTERclockwise and lock it down.
Very easy adjustment. The valve will remain open until approx 4500 rpm.
Hope this helps
1st check: How's the spring look? If it's bent or looks bad, replace it!
2nd: Valve free and turns easy?
put the cap on the spring with no preload (note where the pointer is oriented) turn the spring/cap assembly 180 degrees COUNTERclockwise and lock it down.
Very easy adjustment. The valve will remain open until approx 4500 rpm.
Hope this helps
#12
v8vega350,,i have the same problem that you have but mine is on a lt 250 a went 1.25 over on my piston.the power valve rod don't go up at all.i adjusted the power valve by hand on the left side and it runs a little better but something its wrong.the power valve rod move freely.but i'm going to try the steps from duneadict.
#13
that i how it is adjusted but it is like it just cant push hard enough i can see the lever starting tp push up but it will only wiggle a little bit. i moves perfectly and after it is adjusted i can push it easy. do you know how much pressuer it is supposed to push with
whould this stop it from reving if it is not opening or will it just not make as much power
whould this stop it from reving if it is not opening or will it just not make as much power
#15
v8vega350,i live close to you,i can ride over your house and work with this togheter,if you have a some tools,if not i have plenty of tools at my house,you are welcome.my e-mail is bnarroyo@hotmail.com.plus i have acess to a dyno,when ever i want to.
#16
feel free to come over if your around the west hill of kent just let me know my email address is v8vega350@attbi.com
Thread
Thread Starter
Forum
Replies
Last Post
Hankey Pankey
Performance Mods and Project Quads
3
05-01-2018 01:33 PM
Hankey Pankey
Performance Mods and Project Quads
0
08-17-2015 05:01 PM
ATVC Correspondent
Other ATV Topics
1
08-06-2015 11:49 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)