Older warn winch with 4 post solonoid dial switch can't figure out how to wire handle bar switch. Can I go thru the solonoid or thru the dial switch? Handle bar switch has 3 wires.

 

One wire goes to ignition switch on/off so it cant be run without the key on, other two to solenoid, that is the way my KFI is run. From what I have seen they all seem to be the same.

 

I don't think it will work with both switches hooked up. I would toss the dial switch in the trash if the handlebar switch is the right one.

 

Didn't catch the part about the dial switch....not familiar with that. On my KFI I have a dash switch and added a remote switch and it was just a plug and play except for that darn ignition wire that took hours to snake thru the frame.

 

Thanks for the input, will try with out the stock switch.

 

The Warn Installation Guide, page 7, has a pictograph that roughly describes the basic wiring of a winch install.

It may help you...

https://www.warn.com/atv/winches/pdf/89294A0_rs.pdf


David