i am putting a jet kit on my raptor but i think I lost something, maybe a tube of some sort connecting the two carbs on the exit side????? and I also have a spring that im not sure where it goes????? anyone a blown up view of the carb?

 

found the tube still have the spring

 

If the spring is about 3 inches long, it belongs between the jet needle holder and the vacuum chamber cover, which is the black plastic cap on top of the carb held on by 4 screws.
If it's very small, about 1/2 long, it belongs between the jet needle holder and the clip and spacer, which rests on the upper portion of the needle.

 

i managed to put it all back together but now i need to adjust the fuel/air mixture but Im not sure which screw that is, I hope im not the only one who tried this without the service manual

 

The mix screws are in the center of the carb on the bottom on the engine side.

 

And don't screw them in to tight when your adjusting them the tips can break off real easy.

 

on the lids that you remove to replace the jets????? my neighbor said that was a drain incase you flood. Im new to all this, I hope I get it right

 

ok i got it thx