Raptor clutch boss
#1
Raptor clutch boss
Hi guys. I just reassembled my raptor motor with the '02 tranny (whew, that was fun!) I have just one dilemma. How do i hold the clutch boss steady while I tighten the nut on it? It freespins when i start to torque down on it. I don't want to wedge a screwdriver between the threaded fingers that the pressure plate bolts to, I'm afraid that I'll break one of them off. Raptortranny.com recommends 60 ft pds on the nut and that's alot to hold steady with a screwdriver. Any help will and always be greatly appreciated! By the way, warrior007 rules!
#2
#3
#4
Raptor clutch boss
Go to sears and check out there selection of strap wrenches, they have one that will work I am sure for like $10. Alot of people just run theirs on with an impact while its wrapped in a shop rag or towel - kinda dangerous if you are trying to hold it at the same time though but works just fine
glad you like my site!
glad you like my site!
Thread
Thread Starter
Forum
Replies
Last Post
ATVC Correspondent
Classifieds, Garage Sale & Swap Shop
3
08-21-2015 01:23 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)