HELP! AXLE BENT on Blaster!
#1
#5
HELP! AXLE BENT on Blaster!
A lot of people may disagree but I have some luck straightening axles. I used a heavy duty press and a lathe to see where the bend was. With the high cost of axles it was worth the effort. It's possible that they would bend again but the ones I have staightened didn't. Of course the best way is the new axle but if your low on $$$ it may get you by. If you go with the used one make sure the splines are in good shape. I would roll it on sonething to make sure it's not bent, it was taken out for some reason. Still the best way is the new axle.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)