03 Grizzly 660 won't start
#21
Originally posted by: BartlettRacing
try holding the throttle wide open ,no choke , and hold the start button for a good 30 seconds .......
try holding the throttle wide open ,no choke , and hold the start button for a good 30 seconds .......
another thing is get some "heat", its in a little red bottle and cost like 95 cents, that will keep the water out of your carb and gas tank, works great.
#22
Originally posted by: WarhammerIIC
IT was the Plug!!I installed a brand new, properly gapped plug and on the first turn over she started right up..The other plug was black on the tip with a little black crud in between the insulator and the outside of the plug?The plug its self looks in good condition. Should I clean it up regap and keep it as a spare of just get another new one to keep as a spare.Thanks again for all the help!TF
IT was the Plug!!I installed a brand new, properly gapped plug and on the first turn over she started right up..The other plug was black on the tip with a little black crud in between the insulator and the outside of the plug?The plug its self looks in good condition. Should I clean it up regap and keep it as a spare of just get another new one to keep as a spare.Thanks again for all the help!TF
I bought a few extra plugs so I'm ready for next time.
Still not sure why it fouled
#23
I had the same problem with my 02 grizzly. I had to adjust my choke cable because it was'nt choked all the way. Try taking the aircleaner off and stuff a rag in the air intake and see if it starts better. Mine would'nt start very well if it sat over a week, and wouldnt start at all if it was 30degrees or colder. good luck
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)




