Starter one way?
#1
#2
#3
#6
Starter one way?
Do asap,changed mine after the last trip it was going and then when i took it apart there were already metal shavings all in the gears,and that was from the first trip with it going bad,i had a buddy that let his go till he had to push start it ,i wonder how much metal got in his engine,he was stock though..
#7
Trending Topics
#8
Starter one way?
Yup, change it quick, luckily its located directly nexted to the magneto on the crank so most of the metal shards are collected from the magnet(make sure you clean those off). You are gunna need an 8mm socket to get off cover, a torque wrench (up to like 110 foot pounds i think it is), a large socket (if i remember correctly 22mm), an impact gun (to make taking the crank nut off a whole lot easier), you'll need a 5mm hex socket because you'll have to torque it down and last but not least you will need a 3 bolt pattern flywheel puller. Napa sells a harmonic balancer puller for 18 bucks which is the same exact thing but it doesnt come with the right size bolts, so while you're there make sure you pick em up. But before you work on internal engine stuff you better make sure you have a service manual for torque specs and just to help you through the job. Don't make the mistake of not torqueing those bolts down cause you'll pay for it later, either they'll come loose or you'll try to hard and strip em. Oh and don't forget to drain the oil first. good luck
#10