How to redo the sprak plug
#1
#2
#3
How to redo the sprak plug
You can get a spark plug thread chaser at an auto parts store, you can do it without taking the head off,if you are careful. run the piston all the way up,to limit the room the chips have to fall,put a little grease on the tap, that way,almost all of the chips will stick to it,and it will turn easier.Slowly back it out after fixing the threads, to keep chips from falling off the tap, then open the throttle wide open,put a shop vac on the hole, and run it a while to see if you can get anything out, or take the air box off, and blow an air gun through the intake. I did this on my car, cranked the motor to blow anything out, and it was fine after that. I realize with a 2 stroke, you have the ports in the cylinder, so you don't want to crank it over,or any chips might end up in the motor. This should get you on your way faster,without taking the head off.
Thread
Thread Starter
Forum
Replies
Last Post
Hankey Pankey
Performance Mods and Project Quads
3
05-01-2018 01:33 PM
Hankey Pankey
Performance Mods and Project Quads
0
08-17-2015 05:01 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)