Banshee Carbs??
#13
Banshee Carbs??
The blaster uses the same 26mm carb as the banshee. Blasters do use a different stock needle though which can help depending on what needle your motor needs.
My 34 PJ's are actually off of a 250R. Well one is from a CR250 and the fuel inlet is at a different angle. Also the CR used a 4mm cutaway instead of the 6 that the R used. I had to change that. Lots of KTM's used the 34PJ also. You can pick them up cheap on ebay. Just be prepared to change out the needles, slides, jets, etc to get them the same.
Stock boots crack way to easily. Burning a motor from sucking air through a cracked stock boot is a lot more expensive than just buying a set of intakes.
My 34 PJ's are actually off of a 250R. Well one is from a CR250 and the fuel inlet is at a different angle. Also the CR used a 4mm cutaway instead of the 6 that the R used. I had to change that. Lots of KTM's used the 34PJ also. You can pick them up cheap on ebay. Just be prepared to change out the needles, slides, jets, etc to get them the same.
Stock boots crack way to easily. Burning a motor from sucking air through a cracked stock boot is a lot more expensive than just buying a set of intakes.
Thread
Thread Starter
Forum
Replies
Last Post
ATVC Correspondent
Classifieds, Garage Sale & Swap Shop
0
07-07-2015 11:00 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)