I have a 2001 Blaster and I'm looking to do some mods, what should i do? I was looking at the Toomey B1 or an LRD.

 

When picking out what pipe is best for you, you need to think future mods also. the toomy B1 kit is pretty good but dosn't perform that well on a ported engine.

 

I'm not going to port the engine. I was thinking about doin the exhaust, jets, and air box. What is the best pipe for that?

 

I also want to do a oil injector cut off, how do I that?

 

You can buy oil injection block-off kits for 25 bucks from alot of places. You can check out Vito's or just check in a dirt wheel's mag and there are a zillion places to get them from. If you want to do it for free then PM me and I will expalin how to do it for about 2 bucks...
As for the pipes A toomy or LRD would both be awsome on a stock ported motor..I use a FMF and have no complaints about it, It has a hard hitting top end which I love. Also, Check out CPI, they make a nice pipe and sclincer combo that is souposed to be one of the best, and I think it is only around 300 bucks for the set..

Pipe it, K&N, and jets and you will be ready to go.

 

OK, sounds good. Anybody else have some opinions?

 

well the toomey kit adds more top end so if you want low end you need to gear down. i have to trenga/LRD (look in my gallery to see it) and i like it cause i geared up and it still picks up by it self when shifting from 1st to 2nd, and 2nd to 3rd. the trenga routes down the right side for a cooler look and doesnt blow heat on the motor and has a cool blue red or black silencer

 

I have a power pro's and I have no complaints, it is a great hard pulling pipe. I had mine bought and shipped for about $300.

 

Whem I had My Blaster I had FMF Fatty & a Power Core 2. I liked it so much I put the same Pipes on my Banshee.
And my Buddy has Bills Pipe and Silencer on his Blaster and it sounds Like a Piped 125 Dirt Bike but so did my Blaster

 

I have a Toomey B1 pipe for my Blaster and I love it. It adds a lot of power. If you are going to do any porting or getting a big bore kit then go with the Trenga/LRD. If you are just going to do stuff like air box mods and jetting then go with the Toomey.