ok so now that i put my slide in the right wat it is idling like an oldman on Spam wordSpam word Spam wordSpam word Spam wordSpam word Spam wordSpam word Spam wordSpam word Spam wordSpam word .......lol its going up then going to low idle then that again then it shuts off.......(i did tweak the idle and it didnt help)

 

air leak? bad reeds? Check the reeds visually......if good do a leak down test.

 

Did you adjust the pilot screw. Remember that turing it in will richen the mixture.

 

wich is the piolot screw?????

 

When you are looking at the carb it's just right off the choke..It's a little flat screw that is almost flush with the carb..Usually you tighten it just a bit till it snug's up(not tight at all just snug) and then about 2 full turn's loose is a good place to start..