Yamaha Discussions about Yamaha ATVs.

--- banshee start problem - cleaned the carbs --- changed the plugs --- cleaned the filter --- please help

Old Jan 24, 2006 | 12:47 AM
  #1  
HomeBoy15's Avatar
Thread Starter
|
Trailblazer
Joined: Nov 2005
Posts: 55
Likes: 0
Default --- banshee start problem - cleaned the carbs --- changed the plugs --- cleaned the filter --- please help

normal compression
it takes 50-60 kicks to start
tryied polling the choke 1. full choke 2. half choke 3. off choke

please help
 
Reply
Old Jan 24, 2006 | 01:07 AM
  #2  
HomeBoy15's Avatar
Thread Starter
|
Trailblazer
Joined: Nov 2005
Posts: 55
Likes: 0
Default --- banshee start problem - cleaned the carbs --- changed the plugs --- cleaned the filter --- please help

btw 150 psi in each hole
 
Reply
Old Jan 24, 2006 | 01:39 AM
  #3  
buck183's Avatar
Pro Rider
Joined: Aug 2004
Posts: 452
Likes: 0
Default --- banshee start problem - cleaned the carbs --- changed the plugs --- cleaned the filter --- please help

Check for spark. If all is good there start with fuel. It's usually one of those two.

Buck
 
Reply
Old Jan 24, 2006 | 08:53 AM
  #4  
ZillaRider02's Avatar
Pro Rider
Joined: Dec 2001
Posts: 353
Likes: 0
Default --- banshee start problem - cleaned the carbs --- changed the plugs --- cleaned the filter --- please help

Be sure to check the reeds also.
 
Reply
Old Jan 24, 2006 | 12:44 PM
  #5  
zorro700's Avatar
Pro Rider
Joined: Jan 2004
Posts: 415
Likes: 0
Default --- banshee start problem - cleaned the carbs --- changed the plugs --- cleaned the filter --- please help

Check the small tube that goes between the carbs. Not the big one on top but there is one below that, that connects the actual chokes together. To be sure just replace it. If it is sucking air you actually aren't choking the engine and will make it VERY hard to start.......trust me.
 
Reply
Old Jan 24, 2006 | 06:31 PM
  #6  
GITRDUN's Avatar
Trailblazer
Joined: Jun 2005
Posts: 82
Likes: 0
Default --- banshee start problem - cleaned the carbs --- changed the plugs --- cleaned the filter --- please help

Dont kick your self to death. You must be in better shape than i am if you can kick that thing 50 times. Just give it a shot of starter fluid right down the throat and see if it fires up. If theres spark it will fire in a kick or two. If it runs for a few seconds on the starter fluid then dies you arent getting any gas out of the carbs.
 
Reply
Old Aug 2, 2006 | 05:09 AM
  #7  
Bansheednr's Avatar
Trailblazer
Joined: Jul 2006
Posts: 54
Likes: 0
Default --- banshee start problem - cleaned the carbs --- changed the plugs --- cleaned the filter --- please help

Be sure to check your reeds to see if they are cracked cause this has happened to me before. So i replaced them and it started up.



-------------------------

'91 Banshee
Toomey T5
382cc Pistons
K&N filters
Boost Bottle
Jetted by Trinity Racing

'88 YZ 80 bored to 87cc
DG exhaust system
 
Reply
Old Aug 2, 2006 | 09:31 AM
  #8  
kawiking's Avatar
Pro Rider
Joined: Jun 2005
Posts: 978
Likes: 0
Default --- banshee start problem - cleaned the carbs --- changed the plugs --- cleaned the filter --- please help

reeds,coil-wires(spark),carb tubes. make sure on switch is on and gas on-sorry it happens,ive done it. have you tried to pull start it??
 
Reply
Old Aug 2, 2006 | 11:19 AM
  #9  
MDS2106's Avatar
Range Rover
Joined: Feb 2003
Posts: 168
Likes: 0
Default --- banshee start problem - cleaned the carbs --- changed the plugs --- cleaned the filter --- please help

Air/fuel screws could be out of adjustment.Also to small of size on pilot jets can cause starting problems.
 
Reply
Old Aug 2, 2006 | 05:10 PM
  #10  
Tpsycho's Avatar
Pro Rider
My Bomb Busa is done now and WOW what a rush this thing is scary fast. I love it
Joined: Sep 2004
Posts: 798
Likes: 0
Default --- banshee start problem - cleaned the carbs --- changed the plugs --- cleaned the filter --- please help

Make sure your carb slides are in the rite carb. The dome cut side of the slide should be facing out toward the filter.
 
Reply

Thread Tools
Search this Thread

All times are GMT -5. The time now is 04:56 AM.