I just bought some new headlights for my yamaha raptor. I would like to install them on the front bumper. The lights came with instructions to do a complete wire job. but can't i just splice into the existing wires and use both the stock lights and the after markets?

 

I think 4 lights might be too much for the electrical system to handle. When I had an extra set of lights on my honda recon I could only use one pair at a time constantly, or it would drain the battery faster than it was recharging. I just had it set up that I could turn the accessory lights on when I got to a place that needed extra light, and then flicked them back off when they weren't necesscary.

 

I had my trailtech torch lights set up so they would turn on with the stock light switch in HI. In LOW, Id run the stock lights and when I flipped it to high, it would turn on the trailtechs and the stockers. Just go ahead and splice into the HIGH wire.

 

Thank you, thank you, thank you!!!!

 

Thank you very much!! I will wire them into my high beams only, so i can use my low beams and let the battery recharge when necessary!

Thank you so much!!