Hello, My Grizz is not getting any gas. It turns over and runs for a bit when I spray starting fluid into the carb.

Any Ideas what might be the problem??

Any comments are much aprreciated.

 

is the gas line off ? try tuning it around and back 1 or 2 times see if anything helps ? sorry no help

 

Yep, gas is turned on and is flowing through the line. I disconnected the gasline where it connects to the carb and gas flowed out.

Thanks for the reponse though.

 

Could be a few different things.
How many hours on the motor, and when were the valves last adjusted?
Are you trying to start it with the choke on fully? If you use a steady 1/4 open throttle., while cranking..will it start and run then?
When using the starting fluid...and when it catches and runs...what happens if you hold the throttle at 1/4 open? Does it die, or will it run?
Because you have the air lid off and the filter out (to spray the starter fluid), that will make it very lean, and it will be hard to start. Are you doing this in a cold garage, or in a heated area?