Hello,

I'm trying to replace my axle bearing carrier (both sides) on my Raptor 660. The sproket side bearing went bad and I ended up grinding my whole left side of the hub.

Anyway, I tried pounding the rotor side of the bearing carrier with a mallet and even used a old axle placed inside to try to pry and shake the right piece off to remove the whole thing but I've had no success!

Has anyone ever replaced this part? If so, did you have a hard time removing the entire axle bearing carrier? What did you use to remove it? I'm even thinking about buying a pipe that's just big enough to cover the left side of the carrier where it meets with the right side and trying to pound it out.

Any suggestions would greatly be appreciated !