Does anyone know where and if I can get a by-pass for the parking brake on a Raptor. I want to take the whole stinking thing off. Cable and especially the parking brake lever on the handle bars. This thing has some sensor in it that kicks in the rev limiter. I've got this thing rigged with a tie down as of now.

 

you just need the same brake block off that all the others use...

 

The wire closest to the handle bar goes to a spring loaded pin switch. I traced the wire and behind the clutch side headlight is a 2 prong white plug. I unpluged it and had no problem at all.

 

Thanks for all the info. There has not been no bashing on this topic....This is the reason I visit this WEB site....good technical information.

 

If you unplugg that wire the quad wont start in gear, I had mine unplugged when I took off my Parking brake lever and perch and my raptor would not start in gear so I disconnected the wire from my perch and plugged it back in an zip tied it under my plastic so now my quad starts in gear!

 

if you unplug the two electical things and leave them that way then you can't start in gear. but after you unplug them just plug them into each other and it crosswires them then you can.