need advice on 07 wolverine
#1
need advice on 07 wolverine
long story short got stuck in a mud hole and got hung up on something, only way out was reverse, so when i backed out i peeled back the boot going to the rear axle, its not covered by the skid plate, now its full of water sand and mud, any advice on what to do besides clean the hell out of it, do i need to regrease it... little lost here
#2
#5
need advice on 07 wolverine
there is nothing in that boot but a sealed u-joint. no CV joint. only thing you can do to clean it is to remove the rear axle. It is not that bad. I broke that u-joint at the last race and I had the axle removed in about 45 minutes. you do have to remove the floor boards to get the swing arm bolts out tho.
Thread
Thread Starter
Forum
Replies
Last Post
jrooker6
Polaris
18
04-23-2016 07:36 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)