so i am building a big bore,stroked,blaster..want to replace all bearings in the compression and trans chambers in the case...i have a normal captive bearing puller(three jaws with a expanshion screw to go in the inner bore of the bearing)so the damn catches on the end of the jaws are too thick to get under a few of the blind hole bearings...any sudgestions????????????also a good place to order all bearings from????have to be c3 grade' with the high compression hemi head and turbo blue race fuel and all.thanks

 

Find a socket the same size as the inside of the bearing and hammer it out with the socket on the bearing.

 

a blind hole is one that has a bottom in it...cant push the bearing thru that way.has to be pulled from the in side through the center bore. only has about 1/16 on an inch between bearing and inside of the case.;.just not sure what to use