HELPP.. need a new lock nut for a dura blue axle..???
#1
i have a dura- blue axle and need a lock nut. who makes one that fits my raptor dura blue axle... i can't find one.. my dura blue nut sux.. losens in one lap.. i need a tru lock nut.. anyone have any ideas??? please email me at TASOS311@aol.com for any answers pleaseee.. i'm in need for a new nut.. thanx tom..
#2
Not tring to be rude but did you ever think that you don't have it installed right? Just wondering because I have never had a problem with mine coming loose and I beat my raptor hard.
You should have a C-clip on the outside of the nut (toward the tire) sitting in a groove. If you can not see the groove, spin the lock nut till you can. Once the C-clip is on spin the lock-nut so that it expands and will push itself against the c-clip and brake rotor. Tighten as much as possible then screw in the set screw good and tight.
You should have a C-clip on the outside of the nut (toward the tire) sitting in a groove. If you can not see the groove, spin the lock nut till you can. Once the C-clip is on spin the lock-nut so that it expands and will push itself against the c-clip and brake rotor. Tighten as much as possible then screw in the set screw good and tight.
#3
the durablue locknut is a piece of junk, I can get mine tight (using locktite on the small hex screw)and it might even last a couple of weekends but it always seems to come loose. you'll find plenty of other users here with the same problem, its a poor design, i think you can get a rad lock for it, not sure but i dont think you can install it wrong, if i remember it only goes on one way
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)