I need to buy an extra kn filter for my raptor. anybody bought an extra filter yet?
if so where did you buy it and how much did it cost?
(for a pro-disign)
thanks

01blu660r

 

I just bought one last week from ALBA. They were a little higher than Pro-Design themselves but they had it in stock. I think it was like $90.00 for the filter and outerwear. Pro-Design wanted $79.00 but they didn't have any. I checked EVERYWHERE for this filter and those were the only two places I found that had them. I bought mine from Matt at ALBA and he worked with me a little so ask for him. This is a high dollar filter because they "have to make it special". That seems fine but $90.00 is steep. But its less than what would happen if you were to run with a bad filter and ruin your motor. By the way, they foam and K&N are not supposed to fit on the same flange, but a post on either here or Blue t r a x x says that a guy tried it and they will. Good luck.

Matt

 

LOL, ok i see yamaha has a gyt-r filter set up that looks like the pro-design with a kn filter they sell the kn filter for 59.00 i wonder if it is the same filter?

01BLU660R

 

I'm that guy. (here anyway) I took my sisters pro design foam filter and installed it on my pro design K&N flange. When it slips over the flanges its not as snug as the K&N. This is before tightening. Once tightend it fits snug and does not come off. I have not tried to take my K&N filter and install it on the foam flange. Also CT racing sells them. $62.95

http://www.ctracing.com/raptor.htm