What is the best method to install the large graphics kit?? Is the gel stuff, heat or both?? They are the large tank and rear side panels. Any suggestions??

 

clean it realy good bet some dish soap and a spray bottle just a few drops of soap in the water spray it down and put on push all the water out from under with a cedit card put out in the sun and let sit for a bit and your all set

 

be patient
if your not...you wont be happy with the results
who makes the kit your installing?

 

Here's a link to a review of the ALBA kit with good install info, hope it helps!

http://www.extremegarage.com/reviews/albaraptorgkit.htm

 

It's the Black Swirl kit from Yamaha.

Thanks Guy's

 

<< It's the Black Swirl kit from Yamaha.

Thanks Guy's >>



No it's Alba's Patriot graphics kit for Raptor..

Check out YamahaRaptor.com for more info it's loaded with info for Raptor owners!!

[img]i/expressions/face-icon-small-smile.gif[/img]

 

Sorry for the confusion dataman2, but Cannitor asked me what graphics kit I was installing. I did check out the Alba page and it did help. I was a bit surprised when they said NOT to use a hair dryer.

I'll post pictures when I'm finished.

 

Sorry

Anyway hope I was of some help.....

 

USE THE SOAP AND WATER METHOD!!! i cannot say that enough, i decal RC cars and recommend this...it allows you to move the decal around, position it, and then the soap and water evaporate couple hrs later.....so you get perfect decals and time to move them around...