I hust ordered a kit for my new raptor. It had white bros, e-series, pro flo airbox kit and a jet kit.
How can i find out if the jetting will be correct?

 

From what I gather, do a plug test. Or depending on how the raptor runs after installing the jets. Do a search on here, there has been tons of info posted on what you need.

 

thanks, i figured since they came together from parts direct it would be the correct jets

 

i think it was a dyno jet kit

 

with that setup I believe the dynojet instructions say to use 146/148 mains, needle in 4th groove, air screws out 3 turns, for sea level.

I had the same setup and ran with no lid and then played with the e-series disc system to fine tune. I added 4 more discs to lean it out it was perfect.

if you are lean with the lid off, put it back on to richen it up.

if it is rich with 12 discs, add more to lean it out.

hope this helps.

 

thanks that should help. I trail ride alot.

 

I'm new here. How do i change the pic to the left?

 

click on profile at the top of the page.

 

thanks