Blaster front sproket retainer plate problems
#1
Blaster front sproket retainer plate problems
I was in the middle of replacing both of my sprokets and chain, when I noticed that the front sproket was loose, it was the factory original and both bolt were tight, but you could grab the sproket and wiggle it all around. So before I put the new sproket it on I replaced the retainer plate, because the original one had shown signs of wear, so I thought that was the problem. I put the new one on and you can still wiggle it, but not as much as before. Does anyone know if there is supposed to be play in the front sproket or is it supposed to be tight and not move at all? I would think that it should be tight.
#2
Thread
Thread Starter
Forum
Replies
Last Post
hoopduerr
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
1
06-01-2015 08:22 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)