How is it done and where do I get the tools. I was just going to buy a pre done one but they wanted 70 bucks for the pre done sproket. I understand I have to make a new hole for the set pin on the cam to go into but where do I get the tools and what tools do I need to do the actual degreeing.

 

You still need an adjustable cam spocket. I got one from Alba a few years back.

 

Was this for a warrior?Does someone make one for the raptor?

 

you make an adjustable sproket for the Raptor or the Warrior?[img]i/expressions/face-icon-small-confused.gif[/img] How about some pictures?

 

A slotted stock gear isn't really what I was talking about. I would like to see somebody make a gear, maybe using the stock one, with the amount of degrees you are changing it stamped onto the side of the gear. I just thought this would be something neat if somebody wanted to make a little extra $$$, or some one who already has a shop to do.

 

do you have to degree a stage one hot cam, I have never heard that before, the instruction did say anything about it.

what happens if you dont degree it?

 

You do'nt need to degree the cam when you install it.Changing cam timing will change where your engine makes torque/power.

 

where can i find the spec on how moving the spocket in one direction will effet the power curve?