looking for a wiring diagram for a 2006 hi-bird 250 atv
#1
looking for a wiring diagram for a 2006 hi-bird 250 atv
I am having spark problems with my 2006 hi bird 250 atv, dont seem too have power at the stator, c d i box or coil? this is a learning 4 wheeler already have A KAZUMA ATV AND KIDS RIDE IT ALL THE TIME. i am looking too get any suggestions to work on it or anyone with similar problems? thanks rick
#2
Join Date: Dec 2008
Location: Tracy, California, USA
Posts: 3,260
Likes: 0
Received 13 Likes
on
13 Posts
Rick, how are you determining if you have power from the stator, to the CDI, and to the coil? Are you using a test light? If so you are wasting your time. You need a meter.
Your CDI is 6 pin right (2 pin plus a 4 pin connector)?
Do you know if your CDI is AC powered or DC powered?
Did you verify that you don't have spark by removing the plug, connecting it back up and looking for spark while cranking the engine and holding the plug threads against the engine block?
Have you check your kill switch wiring?
Have you ever seen this quad run, or is this a quad acquired in a non-running and unknown condition?
The purpose of these questions is to give me an idea of where to start .
Your CDI is 6 pin right (2 pin plus a 4 pin connector)?
Do you know if your CDI is AC powered or DC powered?
Did you verify that you don't have spark by removing the plug, connecting it back up and looking for spark while cranking the engine and holding the plug threads against the engine block?
Have you check your kill switch wiring?
Have you ever seen this quad run, or is this a quad acquired in a non-running and unknown condition?
The purpose of these questions is to give me an idea of where to start .
Thread
Thread Starter
Forum
Replies
Last Post
Chocobamofo
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
1
07-10-2015 07:46 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)