Ive tried everything 110cc will not fire
#1
Ive tried everything 110cc will not fire
I started trying to get this atv to run and it ran fine except the battery would die within 15 mins. Trouble shot this and found out voltage regulator was bad. Next I found the remote control by the back axle and didn't know that's what it was at first and grounded the sensor wire and after that it would not fire. I ungrounded the sensor wire and purchased a new cdi, a new voltage regulator, a new coil, and cleaned the carb. I checked the ground and it seemed fine the safety kill switch in the rear the wires have been cut and the toggle switch on handle bars seems to be working ok. I have voltage coming from stator as it turns over. But will not fire I also got a new plug. Any help with this is greatly appreciated im about to pull my hair out.
#4
#5
#7
Trending Topics
#9
Thread
Thread Starter
Forum
Replies
Last Post
Whitetailhunter8955
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
7
07-30-2016 01:22 PM
JoshuaMichael
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
9
07-22-2016 09:58 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)