What are these called bc they're testing open in both directions on mine as well? And does anyone have the pin diagram for the cdi where I can test it also? I appreciate the help

 

You have something seriously wrong if that coil works on a Honda 300 as Honda 300s are CDI ignition and that drawing is for an ignitor ignition with 12v coil. Note positive from ignition runs through 3 amp fuse, through kill switch, and from there via P (pink?) wire to coil and ignitor. Honda 300 has no pos wire to coil. Drawing shows pin out, P positive, G earth, B/Y to coil, B/R and Bl/Y from pickup coil. The little black boxes are diodes, so resistance readings through them should be open circuit one way and no resistance if you swap pos/neg leads from meter round. No idea what they are for on a Linhai but often occur on Hondas etc, in the neutral light/starter lock out, circuit.

 

My cdi on the bighorn isn't exactly wired like the one shown the colors are different. As far as the Honda deal is wired up with 2 wires like this machine I don't know the difference 🤦🏻😂. Mine has different colors hooked but it's 5 wires in an 8 pin cdi

 

Honda 300 coils have a wire from CDI and an earth, no pos, check if one of your wires to coil on the Linnhai is pos with ignition on.12v coils have a pos connector, one for ignitor wire and is usually earthed to frame via the mountings.

That wiring diagram is so simple you should be able to check if yours is the same, the colours may be different but where they come from to the ignitor should tell you what they are. It is possible your machine is CDI ignition, makers changed systems for different models. Kawasaki KLF300s were ignitor, almost identical to that wiring diagram (except colours) but KLF220s were CDI.

 

It is cdi my wire connection where the white/red wires tied into the pink wire from the fuse was bad and I got spark back. Crisis averted now onto my flooding issue

 

I have as big horn 28 2014 according to vin and i can't get any diagrams for
do you mind to send?