Comparing 90cc stock quads top speed to Eton 90
#3
They are all basically made to go around 30 mph with the restrictors removed.Just like anything motorized sometimes you'll get one a little faster or a little slower,even amongst the same brand.Our Viper runs 28 mph with my 50 lb son on it.With my 200 lbs on it,it will still do 26 mph so its obvious there are some more built in restrictors(clutching,pipe design,carburetion etc) holding it back or it would be much faster with my son on it.This pretty much applies to all the mini's.Some may have a better pipe design for example but will be restricted somewhere else to keep the mini around this 30 mph top speed in stock condition.
#4
Been my experience it's how fast you get there that counts. [img]i/expressions/face-icon-small-wink.gif[/img]
#5
my sons race eton will do more than 40, radared at 39 with me on it and was still gaining speed and he is a lot lighter. but it gets there very quickly. i have read where people claim to have minis that do 60 to 65 mph but have yet to see one that has that much top speed and i have seen and built a lot of race minis.
Mark
Mark
#6
Hello
I am a mehanical in Croatia for atv,motorcycle and I have 2t E-ton Draco 100ccm
his top speed is 72km/h, but what is very strange after 1h of riding
top speed is 85km/h again if I refuel it with 95octane fuel his top speed
is 52km/h so try to put in best quality fuel and try to install Denso Iridium spark plugs
I am a mehanical in Croatia for atv,motorcycle and I have 2t E-ton Draco 100ccm
his top speed is 72km/h, but what is very strange after 1h of riding
top speed is 85km/h again if I refuel it with 95octane fuel his top speed
is 52km/h so try to put in best quality fuel and try to install Denso Iridium spark plugs
Thread
Thread Starter
Forum
Replies
Last Post
Frisky2050
Buying an ATV
10
Apr 9, 2020 11:19 AM
KimSJoh
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
14
Jul 18, 2015 07:20 PM
ranvette
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
7
Jul 12, 2015 06:34 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)




