HEY EVERYONE IM BACK! Well sometimes (actually it has only happened a few times, mostly when cold) on my RancherFE when im in Neutral and I rev. the engine it will display a MPH, but 95% of the time it just comes up as zero. Is this a problem? What causes this?
Thanks

 

This is the first time I have heard of this problem. Is the Rancher still under warrenty? If so take it to the dealer & have it checked out.

Otherwise check you two sensors & make sure that are secure.

 

Prob just electrical interference or something, I don't think I would get too excited about it. if you have a newer Chev vehicle try reving it up in neutral and you should see the same thing

 

i wouldnt be too concerned about , my buddies foreman 450 es sometimes doesthe samething but no problems yet.

 

Sounds like an electrical problem, Maybe a short somewhere, wouldnt get to excited but definatly get it checked out as soon as possible. Even if its just asking the dealer (who should know if this is a common occurance) you are better off than just ignoring it. It could be a symptom of a bigger problem, although I doubt it.

 

if the sensors are right next to each other (almost right on top of each other when you stop) then when you stop and there's even a vibration, it may think that you are moving because the sensors are sending signals to each other b/c they're so close to each other.(and moving slightly back and forth)

 

bayou220atv, Now read that back to yourself. LMAO!!!! that's pretty darn funny ain't it?

 

why is that funny? LOL oh, is it supposed to be perverted? LOL, beleive me, not my intentions at all.

 

man it's been this long and I still can't stop laughing!! LMAO too!