Hello,

I've already learned so much just by browsing here...so thanks already! However, I haven't found any mention of the part I need.

I recently acquired a used Coolster 110cc and have the model that has a hose coming out of the back of the air filter and connecting to the crankcase vent. Well the hose that connects directly to the air filter has a crack and barely stays connected. I could probably trim it but if a low cost option exists I would prefer to go that route. The hose is 1.5 - 2 inches long and smaller on the end that connects to the filter and gets bigger where it connects to a plastic looking elbow part. I've searched by every term I can think of and not gotten any results.

Thanks for any help in advance!
~ Tony

 

If it is rubber, superglue, the type that sticks your fingers together, can be used to close a crack up. Alternatively electrical insulation tape wound round the hose works, but is untidy.

 

Id get a Uni Pod filter and remove the bad hose and air filter box.. The Uni Pod clamps on to the end of your carb.