new to forum
#11
new to forum
Hey all,
Just wanted to leave an update and thank everyone for the replies, I finally took the carb off my machine and adjusted my needle to the richest position and it runs great,I'm not sure why it would run ok after it warmed up before but now it runs about 2 min and its ready to go. When I get a chance I may try moving back towards the lean side to if see it gets better or worse but for now it's been an awesome improvement. Apparently the issue was the slide position between 1/8 to 1/4 throttle. Thanks again
Just wanted to leave an update and thank everyone for the replies, I finally took the carb off my machine and adjusted my needle to the richest position and it runs great,I'm not sure why it would run ok after it warmed up before but now it runs about 2 min and its ready to go. When I get a chance I may try moving back towards the lean side to if see it gets better or worse but for now it's been an awesome improvement. Apparently the issue was the slide position between 1/8 to 1/4 throttle. Thanks again
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)